RCV Big Bell Axle Set for REID Super Kingpin Knuckles

$4,195.95

In stock

SKU

CVJ60-SUPER-REID

RCV Performance Big Bell CVs are the ultimate solution designed to fit big knuckles like the Reid Super Kingpin knuckles for Ford Super-60 unit bearings. The Big Bell CVs are our 2.5 ton Rockwell CVs, but the outer stub is designed to fit directly to the large 32 spline 2005+ Ford Dana 60 "Super-60" unit bearing. Eliminating the need for a lock-out or drive flange, increasing strength and reliability.

California Residents
WARNING: Cancer and/or other Reproductive Harm.www.p65warnings.ca.gov

Inner Axle Spline

DRIVER SIDE - axle length

Maximum 100 characters

PASSENGER SIDE - axle length

Maximum 100 characters

DRIVER-The start of the seal surface measurement from inner end of shaft

Maximum 100 characters

DRIVER-The end of the seal surface measurement from inner end of shaft

Maximum 100 characters

PASSENGER-The start of the seal surface measurement from inner end of shaft

Maximum 100 characters

PASSENGER-The end of the seal surface measurement from inner end of shaft

Maximum 100 characters

Differential type

Locker type

Maximum 200 characters

Qty

Skip to the end of the images gallery

Skip to the beginning of the images gallery

Find a Dealer Custom Axle Builder

Details

This kit is designed for custom axles. The Big Bell CV is able to accept a 40 or 47 spline inner axle.

Included in this kit are (2) Big Bell CVs, and two (2) custom length inners at 40 or 47 spline.

Please use measurement guide in Attachment tab to get the proper measurements needed for your order.

CVJ60-SUPER-REID is designed to fit 2005+ Ford F250 & F350 axles with REID Super Kingpin knuckles. CVJ60-SUPER-REID will fit OEM Ford 2005+ F250 & F350 Super Duty knuckles with minor machining inside the knuckle.

Product Attachments